Tools Needed - Canadian Spa Halifax Manuel D'instructions

HOW TO CHANGE A PUMP ON A CANADIAN SPA HOT TUB
TOOLS NEEDED: Phillips CH3 screwdriver, 13mm spanner head, oil filter grip (available at large hardware retailers), Wire- cutters.
IMPORTANT: SWITCH OFF ELECTRICAL SUPPLY BY DISCONNECTING THE PLUG AT THE SOCKET OR ISOLATION SWITCH. Please contact a
qualified electrician if you need assistance or contact us at Canadian Spa
STEP 1 - Unscrew side panels to access pump on the fascia with air
vent and the MP3 Player housing
STEP 2 - Remove panel strips and side panels (on the 'touch pad '
side)
STEP 3 - Uncouple on/off switch to MP3 allowing you to remove the
panel away from the spa and gain access to the pump.
STEP 4 - Shut down both slice valves to isolate water
STEP 5 - Unscrew Control pack cover using a Phillips screwdriver
STEP 6 - Remove clamp to wire - unplug pump plug from circuit
board (ensure cable ties are removed from plumbing)
HOW TO CHANGE A HEATER ON A CANADIAN SPA HOT TUB
Fig 1. Fig 2.
STEP 1 - Unscrew and removeside panels to access pump and
Control Pack.
STEP 2 - Shut down slice valves either side of control box.
STEP 3 - Unscrew face plate of control box using screwdriver (Fig1.)
STEP 4 - Unscrew heater unions either side of the heater using a
pair of grips (Fig 2.). Once the unions have been unscrewed water
from the pipeline will pour out - have a cloth ready in order to mop
up surplus water.
STEP 5 - Unplug heater plug from the circuit board - push tab down
to open (Fig 3.)
How to Guide
STEP 7 - Unscrew earth wire from pump (ensure wire is moved safely
away from pump area)
STEP 8 - Remove all 4 nuts from pump base using a 13mm spanner
head
STEP 9 - Undo pump union joints using an oil filter grip (available at
large hardware retailers).
STEP 10 - Lift pump off the 4 screw pump base and replace with
NEW pump ensuring the screw heads are aligned with pump holes
STEP 11 - To re-assemble reverse the above sequence
Fig 3.
STEP 6 - Unplug sensors plug from circuit board - Push tab down
before pulling out plug (Fig 4.).
STEP 7 - Unscrew both locking nuts on the heater form brackets
using a spanner (Fig 5.).
STEP 8 - Remove heater tube from Control Pack and plumbing
STEP 9 - Install new heater - Please remember to fit new gaskets
STEP 10 - To re-assemble reverse the above sequence
24
Fig 4. Fig 5.