Fit Testing - Honeywell RU6500 Serie Manuel D'instructions

1.7

FIT TESTING

Any respirator with a tight fitting facepiece may not be assigned until the user is given a qualitative or quantitative respirator fit test
and the results of the test indicate that the facepiece of the respirator fits that person properly. The RU6500 Series is available in
three sizes. The letters "S", "M" or "L" on the face seal indicate sizes Small, Medium, or Large. See instructions below for putting
on the respirator. Refer to the most recent OSHA 29 CFR 1910.134 Appendix A (USA), CSA Z 94 (Canada), AS/NZS 1715 for
specific Fit Test procedures (Australia and New Zealand), or Brazilian MTE Respiratory Protection Program.
1.8 KEY TO NIOSH APROVAL LABEL CAUTIONS AND LIMITATIONS FOR AIR-PURIFYING RESPIRATORS
A
Not for use in atmospheres containing less than 19.5 percent oxygen.
B Not for use in atmospheres immediately dangerous to life or health.
C Do not exceed maximum use concentrations established by regulatory standards.
H Follow established cartridge and canister change schedules or observe ESLI to ensure that cartridges and canisters
are replaced before breakthrough occurs.
J Failure to properly use and maintain this product could result in injury or death.
L Follow the manufacturer's User Instructions for changing cartridges, canister and/or filters.
M All approved respirators shall be selected, fitted, used and maintained in accordance with OSHA and other
applicable regulations.
N Never substitute, modify, add or omit parts. Use only exact replacement parts in the configuration as specified by
the manufacturer.
O Refer to User Instructions, and/or maintenance manuals for information on use and maintenance of these
respirators.
P NIOSH does not evaluate respirators for use as surgical masks.
S1 Honeywell and N-Series gas and vapor cartridges manufactured after August, 2012 require the use of a spider
(P/N N750038) when a pad style filter is used with the cartridge.
S2 If the air-purifying cartridges have an ESLI, you must be able to see the indicator without moving the facepiece in
any way that could break the facepiece-to-face seal.
8