Table; General - Atag IG9071MX Mode D'emploi

MAINTENANCE
– Clean the spark plugs preferably with a cloth. Do this carefully. If too
much pressure is applied, the distance from the point of the
sparkplug to the burner may change, causing the burner to ignite
poorly or not at all. The sparkplug will only operate correctly in a dry
environment. If the plug is very dirty, you may clean the point with a
tiny brush.
– Set the pan supports down vertically, without sliding them over the
glass plate. Assemble the burner parts using the guide ridges.
Brass wok burner parts
A few parts of the work burner are made from brass. It is normal for the
colour of the brass to change as a result of the high temperatures that
occur when cooking with a wok.
ATAG Shine
Atag supplies a range of cleaning agents under the name ATAG Shine.
These can be obtained via the website at www.hps.nl, where you will
also find various cleaning and operating tips.
168

general

burner cap
burner cap
Positioneringsnok
Luchtring
burner head
thermocouple
sparkplug
FAULTS INDUCTION
If the appliance does not work properly, this does not always mean
that it is defective. Try to deal with the problem yourself first by
checking the points mentioned below:
Fault Cause
The appliance does not work and No electricity.
the lights are not on.
The hob does not work. The appliance has been connected
F9 or FA appears in the display or incorrectly or the mains voltage is
the appliance immediately starts not right.
to beep when it is connected.
The hob does not work. Two buttons pressed at the same
F99 appears in the display. time, the glass top is dirty or there
is an object lying on the controls.
The fan switches on The appliance is checking itself
spontaneously. after a power failure.
Message F8 appears. Overheating of the electronics in
the hob.
After the zone has been switched Unsuitable pans or no pan on the
on, the zone displays continue to cooking zone.
flash.
The appliance cannot be switched Appliance is locked.
on.
Bringing food to the boil takes Small pan used.
longer than expected.
Fault codes F00 in the display. A control is defective, dirty or has
an object lying on it.
Fault codes F01 – F11 in the Button operated too long or too
display. much damp in the appliance.
Fault codes F1 - F6 in the display. Generator fault.

table

Solution
Check the electrical installation
(main fuse(s), connection).
Check the installation.
Operation error or clean glass top.
The fan switches itself off.
Allow the appliance to cool down.
Press the on/off button and the
indication will disappear. Start
again at a lower setting.
Use a suitable pan.
Keep the button with the key
symbol pressed for a few seconds.
Use a pan with a diameter
approximately the same as the
cooking zone.
Clean the appliance or have it
repaired. Do not place objects on
the control panel.
Clean the appliance or have it
repaired. Do not place objects on
the control panel.
Contact the the service
department.
169