Switching On - Atag HIT900 Mode D'emploi

safety
what you should pay attention to
Do not use aluminium foil, such as the trays from ready-made
meals, for cooking food in.
If aluminium foil melts on the cooking surface, it cannot be
removed.
Grains of sand may cause scratches which cannot be
removed.
• Only put pans with a clean base on the cooking surface.
• Always pick pans up to move them.
• Do not use the hob as a worktop.
Always pick pans up;
never slide them.
GB 6
introductie
Use the correct pan. The induction hob is fitted with a residual heat indicator, a
See the "pans" childproof lock and an automatic cooking-time limiter. On this
page and the following ones, you can read how to use these
section on pages 18
facilities.
and 19.

switching on

1 Put a pan on a cooking zone.
2 Press the on/off button.
A horizontal line (-) appears in the display.
on/off button
setting the power level
1 Press the + or the – button.
The hob goes directly to setting 5.
2 Select a higher or lower setting by pressing the + or
– buttons again.
lower higher
The display shows the setting selected. You can see which
setting setting
setting to select in the cooking tables on pages 12 and 13.
switching off
Press the on/off switch again.
The cooking zone switches off. The residual-heat indicator
will continue to indicate that the zone is hot if it still is.
residual-heat indicator
The indicator shows that the cooking zone is still hot and
goes out as soon as the glass top reaches a safe
temperature.
Residual heat is shown in the display with an H.
residual-heat indicator
operation
switching on
GB 7