Flex FX2241 Manuel De L'utilisateur page 9

WARNING
performing any assembly, adjustments, or
changing accessories. Such preventive safety
measure reduce the risk of starting the tool
accidentally.
TO ATTACH/DETACH BATTERY PACK (FIG. 2)
Place the lock-off button in the locked position.
To attach the battery pack:
Align the raised rib on the battery pack with the
grooves in the tool, and then slide the battery
pack onto the tool.
NOTICE: When placing the battery pack
onto the tool, be sure that the raised rib
on the battery pack aligns with the groove
inside the tool and that the latches snap into
place properly. Improper attachment of the
battery pack can cause damage to internal
components.
INSTALLING AND REMOVING THE SAW
Always lock the tool off
WARNING
pack before making any adjustments or
assembling parts.
Place the lock-off button in the locked position
and then remove the battery pack from the tool.
TO INSTALL THE SAW BLADE (FIG. 3A & 3B)
a. Check the status of the tool-less blade clamp
sleeve, ensure that it is ready to accept a saw
blade. If not, turn the sleeve counterclockwise
to open it (Fig. 3a).
NOTICE: When the tool-less blade clamp
sleeve is in the open state, it cannot be rotated.
b. Use one hand to hold the saw blade and align
the shank of saw blade with the opening of
the tool-less blade clamp. Use the other hand
to hold the saw housing (Fig. 3b).
c. Insert the saw blade into the blade clamp
as far as it can go, until the tool-less blade
clamp sleeve returns to the locked position
automatically and secures the blade in place.
Detach the battery pack
from the tool before
BLADE
and remove the battery
ASSEMBLY
Fig. 2
Attach
Battery-release Button
To detach the battery pack:
Depress the battery-release button located
on the front of the battery pack, to release the
battery pack. Pull the battery pack out and
remove it from the tool.
Fig. 3a
-9-
Detach
Sleeve