Signal Linking; Art-Net™ And Kling-Net Linking; Dmx Linking - Chauvet Professional Next NXT-1 Manuel D'utilisation

Setup And Installation

Signal Linking

The Next™ NXT-1 can receive DMX, Art-Net™, or Kling-Net signal. The Next™ NXT-1 has 2
Neutrik® etherCON® pass through ports, and 3- and 5-pin DMX In and Out ports.
The Next™ NXT-1 can be signal linked to receive one or the other or both types of cables.
Art-Net™ and Kling-Net Linking
Art-Net™ and Kling-Net signals pass through Ethernet cables and the Neutrik® etherCON®
ports in the back of the product, that accept the Ethernet cable, are auto-sensing, so they can
be either an input port or an output port.
The three LED indicator lights in between the two ports indicate that the Next™ NXT-1 is
connected to a network and that there is activity on the network. These lights are not proof
that the Next™ NXT-1 is receiving signal from a controller.
The diagram below shows Art-Net™ or Kling-Net signal linking for three Next™ NXT-1
products.
Router

DMX Linking

DMX signal passes through DMX cables. The Next™ NXT-1 has both 3- and 5-pin DMX In
ports and DMX Out ports. These ports are not auto-sensing like the Neutrik® etherCON®
ports. They can be only inputs or outputs. However, the 3-pin input works with the 5-pin
output, and vice versa.
The diagram below shows DMX signal linking for three Next™ NXT-1.
DMX In With a 5-pin Cable
DMX
And DMX Out With a 3-pin Cable
Controller
With
5-pin Cable
Page 14 of 14
Content Source Or Controller
Next™ NXT-1 Products
DMX In With a 3-pin Cable
And DMX Out With a 5-pin Cable
To Other
DMX
Products
Next™ NXT-1 User Manual Rev. 1