Features - Get To Know The Main Parts Of Your Dryer; Where To Put And Vent Your Dryer - Ariston A35V Utilisation Et Entretien Et Notice D'installation

Features - Get to know the main parts of your dryer

See "The Controls"
Model and
FLUFF FILTER
serial numbers
Clean after
each use
Rating plate
Caution
Hot
Rear venting with hose
NOTE: if your dryer is new wipe out
the inside of the drum before you first
use it to remove any dust which may
have accumulated during transit.
Drum
Air intake
grille
NOTE: When the
dryer is in use,
avoid touching the
back of the machine
as it may be hot.
Vent hose
fitted here

Where to put and vent your dryer

Your Tumble Dryer should NOT be located adjacent to a gas hob
cooker, heater, or eye level grill as flames from the burners could
cause damage to your machine. When the dryer is fitted under a
work surface allow space for air to enter the rear grille, 10mm above
the dryer minimum.
DO NOT use 2-way adaptors or extension leads.
Ventilation
The Dryer dries your washing by drawing in air that is cool, clean
and relatively dry, heating it and then blowing it through the clothes
as they are gently tumbled. The moisture laden air is then blown out
at the back of the dr yer through the vent hose which is
recommended for optimum performance.
When operating the dryer, there has to be adequate ventilation to
avoid the back flow of gases into the room from appliances burning
other fuels, including open fires.
Mobile Venting
A vent hose must always be fitted when the dryer is used in
conjunction with Mobile Venting.
The hose must be fitted securely into the back of the dryer (see
diagram on previous page). If possible, it is always best to connect
the hose to a permanent outlet close to the dryer (see instructions
below).
Ensure that the end of the hose is not directed towards the air
intake grille at the rear of the dryer.
If permanent installation is not possible, the dryer will work just as
well with the hose passed through a partly-opened window.
NOTE: The vent hose should not exceed 2.4 metres in length
and should be kept free of any possible accumulation of fluff,
lint (and water) by frequently shaking it out. Always ensure that
the hose is not squashed.
Fitting the Vent
See diagram on previous page.
Hose Kit
3