Display Messages - DeLonghi DO32852 Manuel D'instructions

Press the Start/pause button (N). The set time is displayed.
If you want to change the time later, repeat the setting proce-
dure described above.
Oven function
In the stand-by state, the Display shows the set time or --:--.
• Press the On/stand-by button (R).
The oven turns on. This is the Function selecting state. The
Default selected function is Bake. The modifiable values
flash.
• Rotate the Function selection dial (S) to select the fun-
ction wanted.
• Rotate the Temperature/weight dial (Q) to set the tempe-
rature if needed (not required in some programmes). In the
Pizza function set the weight. In the Cookies function set the
number of sheets.
• Rotate the Timer dial (M) to set the timer if needed. In the
Both Pizza and Cookies functions have a preset timer.
- In "Pizza" function the time will change depending on the
selected weight.
- In "Biskuit" function it is possible to modify the cooking time.
• Press the Start/pause button (N) to start cooking.
The red ON light (O) turns on.
When the timer expires, the display shows "End" and emits a
acoustic signal (three ' beeps'). Press the On/stand-by button
(R) to reset the oven.
During the cooking process you can pause the oven by pres-
sing the Start/pause button (N).
The red ON light (O) that is located around the edge of the
Start/pause button (N) starts to blink.
Within 5 minutes, press the Start/pause button (N) to resume
the cooking programme, otherwise the oven turns off.
It is possible to interrupt the cooking process at any time by
pressing for 1 second the ON/stand-by button ( R ). The oven
goes into stand-by condition.
In the Bake and Convection functions, the oven emits a single
beep when the first target temperature is reached.
During these functions it is possible to view the cavity tem-
perature by pressing the cavity temperature button (P).
The temperature is displayed for 5 seconds.

Display messages

The appliance must be installed indoors in a room without drau-
ghts and away from sources of heat and direct sunlight.
The display indicates any problems with the appliance.
If " ERR" flashes on the display; the appliance has failed to regu-
late the temperature.
Note the error code on the timer display and take the appliance
to De'Longhi customer services.
13