Ingersoll Rand R30 Information De Produit page 30

93014.15.06
EN
Page 4: Compressor Data
The following are displayed in this section:
• % Energy Savings
• % Capacity
• Package Power
• Power ON Hours
• Running Hours
• Motor Speed
• Time
• Motor Current
• Motor Voltage
• AC Input Voltage
• DC Bus Voltage
• IGBT U Temperature
• IGBT V Temperature
• IGBT W Temperature
• Input Rectifi er Temperature
• VSD Ambient Temperature
• Remote Maximum Speed
• Remote Maximum Pressure
• Target Pressure
Pages 7-8: Digital Inputs
A marked checkbox beside a digital input indicates that the input is in its
TRUE state. For example, Starter Feedback is TRUE when its input is in the
high state, where as, E-Stop is TRUE when its input is at 0Vdc.
EN-30
Figure 56 : Compressor Data
Figure 57 : Digital Inputs
The following are displayed in this section:
• Emergency Stop
• Main Motor Overload
• Fan Motor Overload
• Condensate Drain Error
• Remote Stop
• Remote Start
• Remote Lead/Lag
• Remote Load Enable
• Remote Load/Unload
• Auxiliary Input 1
• Auxiliary Input 2
• Dryer High Pressure
Pages 9-10: Digital Outputs
Figure 58 : Digital Outputs
A marked checkbox beside a digital output indicates that it is energized.
• Starter Contact 1
• Starter Contact 2
• Fan Starter Contact
• Blowdown Solenoid
• Modulation Solenoid
• Condensate Drain
• Dryer Run / Fan Run
• PORO Horn
• Trip Relay
• Warning Relay
• Low Voltage Output 1
• Low Voltage Output 2
• Low Voltage Output 3
• Low Voltage Output 4
(RO) indicates read-only values.
NOTICE
80447162 Rev B