Brake Adjustment - Uline H-4121 Mode D'emploi

BRAKING
1. Locate brake lever on left side of the handle.
Pull brake lever up to apply brake. (See Figure 3)
Figure 3
Lock Lever
Brake Lever
2. Let go of brake lever to release brake.
3. To engage parking brake, pull brake lever up to
apply brake. (See Figure 4)
Figure 4
4. Continue pulling brake lever and slide lock lever into
position. (See Figure 5)
Figure 5
PAGE 3 OF 15
HAND BRAKE INSTRUCTIONS
Brake
Cable
5. Release brake lever. Brake will remain engaged
when truck is not in use.
6. To release parking brake, pull brake lever up and
remove lock lever from position. (See Figure 6)
Figure 6

BRAKE ADJUSTMENT

1. Locate the adjustment nuts on the left side of
handle. (See Figure 7)
Figure 7
Brake Lever
¡ ¢ £ ¤ ¥ ¦ § ¤
 ¢ ¤ £
2. Loosen top and bottom nuts to release tension in
brake cable.
3. Tighten nuts individually, pulling brake lever up as
you go to test brake.
4. Adjust nuts until desired tension and brake power is
achieved.
Brake
Cable
0421 IH-4121