Timer Mode; Cleaning And Maintenance; Safety Information - CASO DESIGN Hot Brew Manuel D'utilisation Original

Please note
► The amount of brewed coffee may differ from the amount of water as coffee grounds absorb
different amounts of water depending on the amount and degree of grinding of the coffee
grounds.
► The device is equipped with a drip stop system which enables you to serve coffee before all
the water has dripped through. Quickly put the coffee pot back in place to avoid any
overflowing.
► Wait a few minutes before brewing coffee again. Let the device cool down.
Warning
► The warming plate is hot during keep warm. Danger of burns.
► Switch the device off when you have removed the last coffee from the coffee pot. Do not
place empty coffee pot on the hot warming plate.
4.2.6

TIMER mode

Finish the "preparations". Press
When the hour digits are flashing, turn the knob to set the hours. Then wait 3 seconds until the
device switches to the minute display. When the minute digits start to flash, turn the knob to
set the minute. Wait briefly (approx. 5 seconds) until the device saves the setting.
Please note
► You can end the TIMER mode by pressing the

5 Cleaning and Maintenance

This chapter provides you with important notices with regard to cleaning and maintaining the
device. Please observe the notices to prevent damages due to cleaning the device incorrectly
and to ensure trouble-free operation.

5.1 Safety information

Attention
Please observe the following safety notices, before you commence with cleaning the device:
► The device must be cleaned at regular intervals and limescale should be removed.
► Pull out the mains plug before cleaning the device.
► The water tank, coffee pot and filter holder with filter are hot after their use. There is a
danger of burns! Wait until the device has cooled down.
► Do not use any aggressive or abrasive cleaning agents or solvents.
► Do not scrape off stubborn dirt with hard items.
twice until TMER symbol lights up.
button again. The white LED goes out.
13