fadini Elpro S20 Mode D'emploi page 12

GB
Elpro S20
ELECTRICAL POWER CONNECTIONS
Accessory
External ashing lamp:
Signal led lights:
Acoustic signal "beeper"
during movement:
PCB power supply:
ELECTRONIC CONTROLLER UP TO 2 AUTOMATIC BOLLARDS,
WITH OR WITHOUT LIMIT SWITCH
Electrical connections
It is possible to connect both the
51 52 53
external
intermittent signal led lights which
are on only during the rising and
lowering movement. The cable for
the connection is the one labelled
as ashing lights cable.
230 V - 100 W max
Output for intermittent signal led
51 52 53
lights during the movement both
rising and lowering and also on
dwell in up position: the lights are
o only when the bollard is in down
position.
Connect the blue-common wire
and the brown wire of the bollard
Signal led lights output
ashing light cable.
230 V - 100 W max
The acoustic signal device inside
51 52 53
the bollard is active duringrising
and lowering. The connection wires
are the blue-common and the
black one of the
cable.
Acoustic signal device
230 V - 100 W max
Electronic programmer power
22 23 24 25
supply.
F N
PCB power supply
230 V ±10% 50 Hz single phase
Dip-switch setting and LED indication of functions
DIP-SWITCH N° 4 and N° 10:
ashing lamp and the
4
10
ashing light
12
ON: pre- ashing
OFF: no pre- ashing
ON: ashing light out of service on dwell time.
Automatic mode
OFF: light ashes on dwell time. Automatic mode