Body Stress; Handling Information; Transport Of The Machine; Checks On Delivery - Sprintus TORANA Mode D'emploi

☞ The machine must be checked before each use.
In particular, check that the battery charging cable
and connector are in perfect condition to ensure safe
operation. If these parts are not in perfect condition,
the machine must undergo further commissioning by
an authorised specialist before being used again.
☞ When spilling foam or liquids the suction motor
must be switched off immediately.
☞ Do not use the machine on textile floors, such as
carpets etc. The use of waxes or foaming cleaning
agents as well as leaks can lead to serious malfunc-
tions of the machine as well as blockage of the hoses.
3.2 BODY STRESS MEASUREMENTS
Noise and vibration data on page 33.
4.

HANDLING INFORMATION

4.1

TRANSPORT OF THE MACHINE

• During lifting and transport, make sure that the
packaged machine has been securely anchored to pre-
vent it from tipping over or falling. When loading / un-
loading the machine onto / off vehicles, suitable lighting
must be provided.
When handling the packaged machine, appropriate
means should be used; Care must be taken to ensure
that the packaging is not exposed to shocks and is not
damaged. Do not turn the packaged machine upside
down and place it gently onto the floor.
☞ These instructions also apply to the batteries
and the battery charger.
4.2 CHECK ON DELIVERY
☞ At delivery of the goods (machine, battery,
battery charger) by the freight forwarder it must be
checked that the packaging and its contents are not
damaged. If the contents of the package are dam-
aged, the freight forwarder must be informed accord-
ingly and a claim for damages must be submitted
in writing. In this case, the machine must only be
accepted under reserve.
4.3

UNPACKING

When unpacking the machine proceed as follows:
For box packaged machine:
- Cut the plastic strapping with a pair of scissors or
a knife.
- Lift up the box and remove it.
- Take the bags out of the compartment and check
their contents (operating and maintenance manual,
connectors for connection to the battery charger).
- Remove the metal straps or plastic straps that se-
cure the machine to the pallet.
- Remove the brushes and squeegee from the pack-
aging.
- Push the machine backwards off the pallet, using a
tilted board well secured to the pallet and floor.
After all the packaging material has been removed,
the accessories and batteries can be installed accord-
ing to the instructions given in the specific section.
It is recommended that all the packaging elements
be retained, as they will protect the machine and
accessories from further transportation to another
location or can be used by an authorised customers
service centre. Otherwise, the applicable laws must
be followed when disposing of the packaging material.
4.4 ASSEMBLY AND ADJUSTMENT OF
THE PUSH BAR
- Insert the handle into its place.
- Set the handle at the desired height and tighten the
2 knobs (photo B-21).
- Insert the suction tube into its place on the waste
water collecting tank (photo B-3).
- Plug the Anderson Safety Connector (photo B-18)
into its connector (photo B-17).
4.5 TRANSPORT OF THE MACHINE,
BATTERY, BATTERY CHARGER
• Do not lift the machine with a pallet truck
as the machine is not intended for this:
- Empty the waste water tank and the cleaning solu-
tion tank. (Photo B-14, B-18)
- Remove the squeegee and brushes.
- Disconnect the batteries.
Move the machine to the original pallet (or other un-
derlay appropriate to the machine weight and dimen-
sions) using a suitable lifting device.
Firmly anchor the machine and squeegee to the pallet.
Secure the machine and the pallet with ropes and
fasten onto the transport vehicle.
If you have a loading ramp, you can also push the
machine directly without a pallet onto the back of
the transport vehicle. However, care must be taken
to ensure that the machine and all components are
protected from shocks, moisture, jolting and sudden
movements during transport.
5. TECCHNICAL INFORMATIONS
5.1

BATTERY

Regardless of the type of construction, the capacity
of a battery is expressed in amperes per hour (Ah).
• The machine is equipped with gel batteries. This
type of battery is maintenance-free and does not re-
quire any special charging facilities (since no harmful
gases are released).
When delivered, reference should be made to the
appropriate manual.
• In no case can it be assumed that non-
original batteries and battery chargers
guarantee the product features warranted by
SPRiNTUS. Only perfect compatibility of bat-
tery and charger ensures first-class perfor-
mance, long life, safety and cost-effectiveness.
5.2

BATTERY CHARGER

The built-in high-frequency battery charger ensures
optimal charging of the battery with high battery life.
• For non-original batteries and battery charg-
ers SPRiNTUS cannot guarantee the warranted
25