Installing 1 Lb. Propane Cylinder - Coleman 9959 Serie Manuel D'assemblage, D'entretien Et D'utilisation

Set up the Grill
■ Rotate counterclockwise the leg locker to release.
■ Place foot on towing handle, grasp fixed side table
handle and lift. (Fig. 17)
■ Continue to pull the fixed side table toward you until
stand is fully extended. (Fig. 18)
Fig. 17
■ Lower grill and slide grill
back until leg extensions
lock into brackets on
bottom of grill stand.
(Fig. 19, Fig. 20
and Fig. 21)
Pull
Fig. 20
Install the Grease Cup
■ Pull apart the grease cup holder and insert it into drip
hole on bottom center of grill base. (Fig. 22)
■ Attach grease cup to grease cup holder. (Fig. 23)
Pull
Pull
Fig. 22

Installing 1 lb. Propane Cylinder

NOTE: Your 9959 Series grill is set up from the factory to
use a 1 lb. disposable propane cylinder.
Only cylinders marked "Propane" must be used.
This procedure MUST be performed OUTDOORS only!
Read and follow the directions on the cylinder.
Lock
WARNING
WARNING
• NEVER store a spare L.P. gas supply cylinder under the
grill body or inside the grill enclosure or in the vicinity of
any heat producing appliance.
Failure to follow this information exactly could result in an
explosion and/or fire causing death or serious injury.
Tighten by hand only. DO NOT use tools.
Fig. 18
■ Before attaching propane
cylinder make sure both
control knobs are closed.
(Fig. 24)
Fig. 19
■ Remove plastic cap from
top of propane cylinder
and screw cylinder into
regulator hand tight.
(Fig. 25)
Fig. 21
■ To open lid, release both
cover latches and lift up.
(Fig. 26)
Fig. 23
DO NOT operate the grill with side tables in storage
position. Damage will occur and void the warranty.
■ To extend sliding side
table, grasp its handle
beneath the grill and
slide out until fully
extended. (Fig. 27)
English - 6
DANGER
CAUTION
WARNING
Fig. 24
Fig. 25
Fig. 26
Fig. 27