Installing The Profile Cylinder - Forster 906443-448 Notice De Montage

Fig. 12 :
Assembling a door fitting
Typical assembly of a
locking cylinder
Fig. 13 :
Assembling a locking
cylinder
Assembly

Installing the profile cylinder

The lock must be installed in the door before the profile cylinder can be installed ("Assemble safety lock", page 43,
"Accessories", page 52). The profile cylinder must match the door leaf thickness and the door fitting and protrude at
least 3 mm from the door fitting when the door is complete.
Install the profile cylinder as described in the accompany instructions. The following installation steps are typical:
1 Place profile cylinder in the profile cylinder cut-out (Fig. 13).
2 Fix it in place with the cylinder fixing screw.
3 Test the key for ease of movement.
 You have installed the profile cylinder and can operate the lock with a key.
2
2
1
2
2.
6
3
4
5
4
4
1
1.
EN
49