Controls - Sonnenkonig CUBY Mode D'emploi

03 - CONTROLS

Plug in the heater. Make sure that there are no combustible materials within a radius of 2 me-
ters.
0
The heater fan is switched off.
Cold stage; only the fan is running.
I
Low heating level (750 W)
II
High heating stage (1500 W)
Thermostat
The thermostat works only on level I or II. Turn the thermostat clockwise to increase the hea-
ting power.
Using the ventilation
• Turn the left switch to
• If the fan does not adjust, the room air is colder than the integrated thermostat at the „0" position.
Turn the right switch (thermostat) clockwise and the fan should adjust.
• Once the fan turns on, the red indicator light on the unit will illuminate.
Using the heating levels I and II
• Turn the left switch to position I for the low heating level or to position II for the high heating level.
• Regulate the heat emitted with the thermostat (left switch).
• The thermostat will turn off when the room reaches the desired temperature and turn back on
when the room temperature drops again.
• For maximum heat output, use heat level II and turn the thermostat to the maximum. This is
useful to bring the room up to temperature. After that, the fan heater can be operated on the low
heating level.
Overheating
• The fan heater is equipped with overheating protection. The device switches off automatically.
• Overheating can be caused by objects closer than 2 meters or if the device is covered. In this case,
turn off the device and disconnect it from the power supply. Let the fan heater cool down for about
half an hour and plug it in again.
Tilt protection
The device has a button on the underside which checks that the device is in permanent contact
with the floor. Otherwise, the device assumes that it may have fallen over and stops operation.
EN
28 28
. The room air is now only circulated, but not heated.