Cleaning And Maintenance - Dometic ECOLINE CL440LDC Instructions De Montage Et De Service

CL440, CL460
➤ Place the cooling device on a firm base.
➤ Connect the connection cable to the AC mains supply.
✓ The cooling device starts cooling the interior.
➤ Set the temperature controller (fig. 1 1, page 3) to the desired position:
– max: lowest temperature
– min: highest temperature
➤ If you wish to switch the cooling device off, pull out the connection cable.
➤ Clean the interior to make sure it is dry enough.
6.3 Locking the door
➤ Turn the key a quarter turn to the left to lock the cooling device (fig. s, page 10).
6.4 Changing the LED light
➤ Change the LED light as follows: fig. t, page 10.
7

Cleaning and maintenance

!
WARNING!
Always disconnect the device from the power supply before you clean
and service it.
A
NOTICE! Risk of damage
• Never clean the cooling device under running water or in dish water.
• Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the cooling device.
➤ Use a soft cloth, lukewarm water and a mild detergent to clean the inside of the
cooling device.
➤ Wash out the cooling device using clean water and dry thoroughly.
➤ At annual intervals, remove dust from the cooling aggregate at the back of the
cooling device using a brush or a soft cloth.
EN
Cleaning and maintenance
17