Using The Machine - Nilfisk GM 80 Mode D'emploi

either the positive twist safety latches or the standard latches,
depending on which option you purchased.
. Installing the Polyliner and Paper Bag: Twist and release the two
positive twist safety latches, or the standard latches, depending on
your machine. They are located on the body of the container, front
and back. Lift off the top. Open the polyliner and place in the
bottom of the container with its walls flush against the container
sides and lipped under the container inlet (photo 3). The excess
length of polyliner is draped over the top of the container and
Photo 3
down the outside then rolled at the end to permit the container
clips to close.
Install a paper bag inside the polyliner according to the
illustrations printed on the paper bag itself (photo 4). Replace the
top container and fasten the two clips.
Photo 4
Photo 4
4. The GM 80 and GM 80i offer a package of standard accessories that can be connected
in the following manner. Affix the vacuum hose to the vacuum by inserting it into the
orifice on the lower container. Once it is inserted, rotate the inlet coupler a quarter turn to
lock it into place. Either of the two straight 22 inch wands can be fitted to the other end of
the hose. You can connect the combination floor nozzle or 5 inch upholstery nozzle to the
end of the hose. The rubber crevice nozzle and the 3 inch round brush can be connected
to the end of the straight wand or the curved steel tube of the hose. There is a list of
optional accessories that can be supplied for both models. Please consult your District
Sales Manager or the Customer Service Department at (800) NILFISK for a list of
optional accessories.

USING THE MACHINE:

Starting and stopping: Press the gray button on the upper
front portion of the vacuum (photo 5).
Photo 5
Correct use of the machine: This machine is not a wet/dry vacuum. It is intended for dry
collection only. Do not use this vacuum to pick up liquids, or any wet materials.
4