Maintenance And Cleaning; Technical Data; Fuse Replacement - Conrad BASETech 1380436 Mode D'emploi

• Briefly press the "TIME" button and the hours will flash; set them using the "UP" or "DOWN"
button. For a quick adjustment, press and hold down the corresponding button for a while.
• By briefly pressing the "TIME" button, you can now switch to setting the minutes, year, month
and date. Settings are made with the "UP" or "DOWN" button (hold the corresponding button
for a while for quick adjustment).
Once the date is set and you briefly press the "TIME" button, the settings are saved and the
setting mode is closed.
The setting mode will automatically close if you do not press any buttons for 1 minu-
te. The settings already made are saved.
c) Toggling time/date
• Briefly press the "TIME" button and the month and date will be shown in the display.
• To display the time again, briefly press the "TIME" button again or wait for 10 seconds.
d) Toggling °C/°F
Briefly press the "°C/°F" button to switch between °C (degrees Celsius) and °F (degrees Fah-
renheit).
e) Changing the colour of the background light
The background light is only activated if the cigarette lighter plug is inserted into
a corresponding 12 V cigarette lighter socket and voltage is present (the battery
voltage is also shown in the display).
A voltage is only present at the cigarette lighter socket in most vehicles when the
ignition of the vehicle is activated or the engine is running.
The colour of the background light can be toggled between "blue" and "orange" using the sliding
switch on the left side.
f) Frost alarm
• Keep the "DOWN" button pressed for 3 seconds to switch the frost alarm on or off. A snow-
flake symbol appears above the outside temperature when the frost alarm is activated.
• If the frost alarm is activated, the snowflake symbol flashes if the outside temperature ("OUT")
is between -1 °C and +4 °C.
g) Voltage display
The voltage display on the right only appears if the cigarette lighter plug is inserted
into a corresponding 12 V cigarette lighter socket and voltage is present. The back-
ground light is also activated.
A voltage is only present at the cigarette lighter socket in most vehicles when the
ignition of the vehicle is activated or the engine is running.
Important!
Check if there is continuous voltage present at the cigarette lighter socket to which
you connect the product, even when the ignition of the vehicle is switched off.
If this is the case, always remove the cigarette lighter plug of the product from the
socket when you are not using the vehicle as the display is supplied with voltage/
current from this source. Otherwise, the vehicle battery can totally discharged.
A battery symbol in the display next to the voltage (in volts) indicates the battery condition.
" " Voltage < 9.0 V
" " Voltage 9.1....11.5 V
" " Voltage 11.6....11.9 V
" " Voltage 12.0....12.4 V
" " Voltage 12.5....12.9 V
" " Voltage 13.0....15.0 V

Fuse replacement

A fine fuse (5 x 20 mm, 250 V, 1 A, smart triggering characteristic) is integrated in the cigarette
lighter plug. If the display light does not go on even though there is voltage at the cigarette
lighter socket of your vehicle, replace the fuse with a new one.
Unscrew the furrowed nut from the tip of the cigarette lighter plug. Replace the defective fuse
with a new fuse identical in construction.
Never bridge a defective fuse! Always use a fuse with the same nominal current and
triggering characteristics!

Maintenance and cleaning

• The product is maintenance-free for you; you should not dismantle it (except for inserting/
replacing the batteries as described in these operating instructions).
• The outside of the product should be cleaned only with a clean, soft, dry cloth.
Do not use aggressive cleaning agents or chemical solutions for this could damage the
housing (discolouring) or impair the operation.
• Dust can be easily removed with a brush and a vacuum cleaner, if necessary.
Disposal
a) General
The product must not be disposed of in the household waste!
Dispose of the product at the end of its service life according to the current statutory
requirements.
Remove the batteries that may be inserted and dispose of them separately from the
product.
b) Batteries and rechargeable batteries
As the end user, you are required by law (Battery Regulation) to return used batteries. Do not
dispose of used batteries in the household waste!
Batteries/rechargeable batteries containing hazardous substances are labelled with
these symbols to indicate that the disposal of them in the household waste is forbid-
den.
The symbols of the critical heavy metals are: Cd=Cadmium, Hg=Mercury, Pb=Lead
(name written on the battery/rechargeable battery, e.g., under the rubbish bin sym-
bol on the left).
You can return your used batteries/rechargeable batteries free of charge at the official coll-
ection points of your community, in our stores, or at places where batteries or rechargeable
batteries are sold!
You thereby fulfil your statutory obligations and contribute to the protection of the environment.

Technical data

Operating voltage ......................... 3 V/DC (2x batteries of type LR44 = AG13); the voltage/
current supply for the display light is supplied via the
cigarette lighter plug
Measuring range ........................... Indoor sensor: -50 °C to +70 °C
...................................................... Outdoor sensor: -50 °C to +70 °C
...................................................... Voltmeter: 9.0 to 15.0 V/DC
Cable length ................................. Outdoor sensor: approx. 140 cm
...................................................... Cigarette lighter plug: approx. 145 cm
Fuse type ...................................... in cigarette lighter plug, 5 x 20 mm (Ø x L), 250 V, 1 A,
smart tripping characteristics
Ambient conditions
for the display unit ........................ Temperature -20 °C to +70 °C, air humidity 10% to 90%
relative, not condensing
Dimensions ................................... 114 x 25 x 30 mm (W x D x H)
Weight .......................................... 95 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represent the technical status at the time of printing.
© Copyright 2017 by Conrad Electronic SE. 1380436_V4_0917_02_VTP_m_en