Digital Display & Controls; Unpacking & Installation - Waring Commercial WWB3G Serie Mode D'emploi

DIGITAL DISPLAY & CONTROLS
Standby – turns power on and
off to the controls.
Temp/Time – Press to set the
temperature. Press and hold to
set time.
Arrows – Use to adjust settings.
Start – Press to start the heater.
Night Mode – Press to activate
night mode.
Light Bulb – Press to illuminate
the display.
UNPACKING & INSTALLATION
CAUTION: This is a heavy piece of equipment. It is recommended
that moving or lifting the unit be done by two people to avoid injury.
Carefully unpack the machine and make sure there was no damage
during shipping. Contact customer service if you notice any issues.
NOTE: The person installing the appliance is responsible for
ensuring that electric and water connections meet the requirements
of the national electric code, national plumbing code, and any local
ordinances.
INSTALLATION
1. Find a location near a water connection.
2. Remove the hot water dispenser from the packing material.
Remove drip tray from packing material (bottom of package).
3. Carefully stand up the hot water dispenser and place it on a
flat, sturdy surface where it will not be knocked into. Be sure to
leave at least 6" (15 cm) from the back of hot water dispenser for
proper venting. Position hot water dispenser so that the faucet
can be easily accessed.
4. Slide the drip tray into slots underneath.
DIGITAL DISPLAY ICONS
7
NIGHT
HEATING
MODE