ALPHA-TOOLS ASE 20,4 Mode D'emploi page 10

GB
Tool illustration:
Figure 1: Torque adjustment
facility
Figure 2: Changing over from
1st gear to 2nd gear
Figure 3: Forward / Reverse
selector switch
Figure 4: On/Off switch
Figure 5: Removable battery
pack; press both
clips to take out the
battery pack
Important notes:
It is imperative to read these notes
before putting your battery-powe-
red drill/screwdriver into operation:
1. The removable Ni-Cd battery
pack supplied with your bat-
tery-powered drill/screwdriver
has to be charged before you
use the tool for the first time.
2. Use the supplied battery char-
ger to charge the battery pack.
It takes a maximum of 1 hour
to charge an empty battery. Do
not use the supplied battery
charger to charge any other
tools or appliances.
3. The battery pack reaches its
maximum capacity after
approx. five discharge/charge
cycles.
4. Ni-Cd batteries will also
discharge when they are not in
use. It is recommended, there-
fore, to charge the batteries
regularly.
10
5. Please note the data quoted on
the rating plate of the battery
charger. Operate the charger
only from the same mains
voltage as that quoted on the
rating plate.
6. In periods of heavy duty the
battery pack will grow warm.
Allow the battery pack to cool
to room temperature before
starting to charge it.
Safety regulations:
1. Protect your battery-powered
drill/screwdriverand charger
from the damp and rain.
2. Keep the charger and battery-
powered drill/screwdriver safe
from children.
3. Use only sharp drill bits and
undamaged, properly fitting
screwdriver bits.
4. Wear suitable working clothes
and safety goggles.
5. Never use the battery-powered
drill/screwdriver and charger in
the vicinity of vapours and
combustible liquids.
6. Look for concealed electric
cables, gas pipes and water
pipes before drilling and scr-
ewdriving in walls.
7. Never throw old batteries into
an open fire. Risk of explosion!
8. Avoid contact with leaky batte-
ries. Should contact arise