Troubleshooting - Lofrans Cayman 88 Manuel D'installation & D'utilisation

7 TROUBLE SHOOTING
Problem
1.1
1.2
1 The anchor windlass does
1.3
not work when a control is
operated
1.4 Failure of the control
1.5
2.1 The chain locker is not deep enough with respect to the
quantity of chain chosen
2 The chain jams frequently 2.2 The chain is not suitable for the gipsy
2.3 The chain is not calibrated
3.1 Unsuitable cable sections
3.2 Deck floors not parallel
3.3
3 The anchor windlass turns
slowly
3.4
3.5 Water infiltrations in the electric motor
Possible causes
Protection switch in OFF position
Lack of voltage in the system
Failure of the control box
Failure of the electric motor
Bad electrical connections
Dirty brushes
www.busse-yachtshop.de | info@busse-yachtshop.de
Verricello Salpa Ancora mod. Atlas / Cayman 88 / Tigres / Falkon
Solution
1.1 Check the protection switch and set it in the ON position
1.2 Check the charge status of the battery, check connections
1.3 Check and possibly replace the control box
1.4 Check and possibly replace the control
1.5 Measure the electric motor voltage; if it is OK, check the brushes and clean them. If it does not
work, replace the electric motor
2.1 Position the anchor windlass in the deepest point of the chain locker or reduce the quantity of
chain
2.2 Change the gipsy
2.3 Check the chain: if it does not meet the tolerances, it must be replaced
3.1 Increase cable section
3.2 Make floors parallel by interposing thicknesses
3.3 Check connections
3.4 Clean brushes
3.5 Replace the electric motor
25