Operating Hand Tool; Draining Tanks - Tennant NOBLES EX-CAN-15-LP Manuel Opérateur

3. Push floor tool forward over same path with trigger
released when returning for next stroke. Continue
this pull and push method with a slight overlap of
each stroke.
NOTE: For heavily soiled areas, repeat stroke or
change angle of stroke.
4. Check for excessive foam buildup in recovery tank.
Use a recommended foam control solution to
prevent vacuum motor damage.
ATTENTION: Excessive foam buildup will not
activate the float shut-off screen. Vacuum motor
damage may result.
5. When finished cleaning, turn off switches and drain
recovery tank (See DRAINING RECOVERY
TANK).
6. After cleaning, relieve water pressure from
accessory tool before disconnecting hose.
Squeeze trigger for five seconds after turning off
the machine.

OPERATING HAND TOOL

Optional accessory tool is required.
FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
NOTE: This machine cleans most synthetic upholstery
very well. Fabrics like Herculon and synthetic velvets
will clean with excellent results. Extraction is not
recommended for most cottons, silks, wools or natural
fiber velvets. Check cleaning instructions sewn in
furniture by manufacturer for further instructions. Extra
caution should be taken with furniture that has been
re-upholstered. Any material under new upholstery may
bleed and discolor new fabric.
NOTE: Vacuum upholstery before cleaning.
1. TEST FABRIC FOR COLORFASTNESS. Pour a
small amount of cleaning solution on a white cloth.
Hold damp portion of cloth against an area of
upholstery which is hidden from view. Hold it there
for 60 seconds. If no color transfers to the cloth, it
should be safe to clean. However, always use your
best judgement.
2. Activate vacuum and pump switches.
3. Place hand tool on fabric and squeeze trigger while
applying pressure on fabric and slowly pull tool
backwards. Be careful not to over wet upholstery.
Repeat stroke without spray to get fabric as dry as
possible. Overlap cleaning strokes to avoid
streaking (Figure 5).
EX- -CAN- -15- -LP / EX- -CAN- -57- -LP (04- -10)
Home Find... Go To..
FIG. 5
WARNING: Do Not Pick Up Flammable
Materials Or Reactive Metals.
ATTENTION: Do not allow water or foam to enter
float shut- -off screen in recovery tank.
4. When finished cleaning, turn off switches and drain
recovery tank (See DRAINING RECOVERY
TANK).
5. After cleaning, relieve water pressure from
accessory tool before disconnecting hose.
Squeeze trigger for five seconds after turning off
the machine.

DRAINING TANKS

FOR SAFETY: Before leaving or servicing machine,
unplug power cord from wall outlet.
ATTENTION: Use different buckets to fill and drain
machine to prevent solution system clogs.
DRAINING RECOVERY TANK
NOTE: When solution tank becomes empty, recovery
tank must be drained.
1. Turn off machine and unplug power cord.
2. Remove drain hose from holder, position hose over
floor drain and twist off knob to drain
(Figure 6).
FIG. 6
OPERATION
EN
7