Machine Setup - Tennant NOBLES EX-SPOT-2 Manuel Opérateur

MACHINE SETUP

1. Unfasten two latches which hold recovery tank to
solution tank. Lift recovery tank off solution tank
(Figure 1).
2. Pour up to 7.5 liters (2 gals) of hot water into
solution tank. Water temperature must not exceed
60C (140F). If you are only cleaning a small spot,
pour in less water. The label on solution tank shows
water level (Figure 2).
WARNING: Do Not Use Flammable Liquids Or
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
This machine is not equipped with an explosion
proof motor. The electric motor will spark upon
start up and during operation which could cause a
flash fire or explosion if machine is used in an area
where flammable vapors/liquids or combustible
dusts are present.
EX- SPOT- 2 / EX- SPOT- 8 (04- 10)
FIG. 1
FIG. 2
3. If desired, add liquid cleaning solution to clean
water. See proper dilution as instructed on the
cleaning solution bottle.
FOR SAFETY: When using machine, follow mixing
and handling instructions on chemical containers.
ATTENTION: Do not mix powdered chemicals in
solution tank. Mix powdered chemicals thoroughly
in a bucket before pouring into machine. Powders
are unlikely to dissolve completely and can clog
solution pump system.
4. Replace the recovery tank onto the solution tank
and fasten the two latches.
5. Plug power cord into a grounded power outlet
(Figure 3).
WARNING: Do Not Operate With Damaged
Power Cord. Do Not Modify Plug. Unplug Power
Cord Before Servicing Machine
If the supply cord is damaged or broken, it must be
replaced by the manufacturer or it's service agent
or a similarly qualified person in order to avoid a
hazard.
Grounded
3 Hole Outlet
Ground Pin
(120V)
FOR SAFETY: Do not operate machine unless cord
is properly grounded.
FOR SAFETY: Do not operate machine with the use
of an extension cord.
OPERATION
Grounded Outlet
Grounding
Edge/hole
(220V/230V/240V)
FIG. 3
EN
5