Installing The Lever; Attaching The Lance To The Trigger Valve (Starting And Stopping); Inverting The Lever Position; Tightening The Fastening Nut - Jacto HD 400 Manuel De L'opérateur

3.3. Installing the lever

• Lightly greases the orifice on the chamber top.
• Fit a flat washer on the shaft and rod.
• For easy assembly, install the lever on the shaft and the rod
on the chamber top at the same time.
• Install the other flat washers on the shaft and rod and lock
with the lock ring.
Locked
ring
Flat
washers
Rod
Lever
Locked
ring
3.4. Attaching the lance to the trigger valve
(starting and stopping)
• Push the lance into the trigger valve and secure it with the
screw cap.
Screw cap
Elbow
Lance
Trigger valve
4/68
Shaft
Flat
washers
Trigger
valve
Screw cap
Hose
WARNING!
Do not overtighten the screw cap.

3.5. Inverting the lever position

This sprayer is assembled to mount the lever for left hand opera-
tion. In case you wish to change its position, proceed as follows.
• Remove the lock ring (1) and washers (A) and the rod (2) of
the chamber top.
• Turn the chamber top 180°. Reinstall the rod (2) on the cham-
ber top, fit the washers and secure the rod with the lock ring
(1) again.
• Then, remove the lock ring (4 and 5) and the washers. Re-
move the lever (6) and the shaft (7).
• Unfasten the strap assembly (8) and mount it on the other
side of the sprayer as shown in the detail below.
• Install the shaft on the other opening on the tank base; pro-
ceed as instructed in the item 05.
• Fit the washers and mount the lever (6) on the rod oriented to
be operated with the right hand.
5

3.6. Tightening the fastening nut

Before using the equipament, tighten the fastening nut (A).
Important: This operation must be carried out using the hand.
Never use any type of tool.
A
1
A
2
8
4
7
6