Introduction; Specifications; Preparing The Product For Use; Unpacking - Jacto HD 400 Manuel De L'opérateur

1. Introduction

This manual contains information for the proper assembly, op-
eration and care of your sprayer. Carefully read and follow the
instructions contained in this manual before using your sprayer.
This equipment was designed for spraying plants protection
products approved by regulatory authorities to be used in knap-
sack sprayers.

2. Specifications

Model
Net weight
Gross weight
Spray lance length
Hose length
Chemical tank
Capacity
Filling opening diameter
Material
Pump
Type
Maximum working pressure
Nozzle installed
Material
SAFETY GUIDELINES – DEFINITIONS
It is important for you to read and understand this manual. The infor-
mation it contains relates to protecting YOUR SAFETY and PREVENTING
PROBLEMS. The symbols below are used to help you recognize this in-
formation.
DANGER!
Indicates an imminently hazardous situation which, if not avoid-
ed, will result in death or serious injury.
WARNING!
Indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
CAUTION!
Indicates a potentially hazardous situation which, if not avoided,
may result in minor or moderate injury.
Notice: Used without the safety alert symbol indicates a potentially haz-
ardous situation which, if not avoided, may result in property damage.
SAVE THESE INSTRUCTIONS: This manual contains important
safety instructions for the proper use and maintenance of this
product.
HD 400/ 550
3.7 kg/ 4.2 kg
4.3 kg/ 4.9 kg
600 mm
1650 mm
16 L/ 20 L
115 mm
Polyethylene
Piston
75 psi (5.1 bar)
Blue adjustable cone
Polypropylene

3. Preparing the Product For Use

3.1. Unpacking

Remove from the sprayer carton the following parts:
Haste
Lever
Lance
Manual
Accessories
plastic bag
NOTE: Minimum space needed for use, maintenance and repair
is 1,5 m².
WARNING!
Be careful when taking out the sprayer out
of the carton because the lever is loose and
can cause damage or personal injury. Note
that the agitator is loose inside the tank and
must be properly assembly.
NOTE: Carton can be discarded in recyclable waste.

3.2. Installing the shaft

• Insert the shaft (1) in the free opening on the tank base (on
the same side of the chamber).Fit the shaft lock (2).
Shaft
(1
)
Tank
Hose
Trigger
valve
Contents of the
plastic bag
Shaft
lock(2)
3/68