Kärcher KM 130/300 R D Mode D'emploi page 7

Operating and Functional
Elements
Ignition lock
30 Ignition key
Filament symbol : Pre-heat
Position 0: Switch off engine
Position 1: Ignition on
Position 2: Start the engine
Function keys
32 Beacon lamp on/off
33 Horn
35 Blinker switch
Indicator lamps
40 Operating hour counter
41 Charge warning lamp
42 Oil pressure warning lamp
43 Cooling water temperature warning
lamp
44 Motor suction air
45 Warning lamp fuel reserve
46 Preglow indicator light
47 Indicator lamp (not connected)
48 Indicator parking light (option)
49 Indicator light low beam (option)
50 Indicator light blinker (option)
51 Indicator lamp - forward driving direc-
tion
52 Indicator lamp - reverse driving direc-
tion
53 Tank indicator
Pedals
A Brake pedal
B Drive pedal
C Parking brake
Start up
General notes
 Read the operating instructions of the
engine manufacturer before start-up
and follow the safety instructions care-
fully.
Refuelling
Danger
Risk of explosion!
Only use the fuels specified in the Op-
–
erations Manual.
Do not refuel the machine in enclosed
–
spaces.
Smoking and naked flames are strictly
–
prohibited.
Ensure that no fuel reaches the hot
–
open surfaces.
 Check fuel level via the tank indicator.
 Switch off engine.
 Open the tank lock.
 Fill in diesel.
 Wipe off any spilt fuel and close fuel fill-
er cap.
Operation
Programme selection
1 Transport drive
2 Sweeping with sweep roller
3 Sweeping using roller brush and side
brushes
2
-
EN
Lock/ release parking brake
 Loosen parking brake; press brake
pedal at the same time.
 Activate the parking brake; press brake
pedal at the same time.
Adjusting driver's seat
 Pull seat adjustment lever outwards.
 Slide seat, release lever and lock in
place.
 Check that the seat is properly locked in
position by attempting to move it back-
wards and forwards.
Adjust engine speed
 Correctly adjust the motor speed using
the gas lever
Starting the machine
Note:The machine is equipped with a seat
contact switch If the driver's seat is vacat-
ed, the machine is switched off.
 Sit on the driver's seat.
 Bring the direction selector switch into
the middle position.
 Lock parking brake.
 Engine speed adjustment - push for-
ward by 1/3.
Pre-heat
 Insert the ignition key into the ignition
lock.
 Turn the ignition key to position "Fila-
ment".
Pre-heat lamp glows.
Start the engine
 When the pre-heating lamp goes off,
turn the ignition key to position "II".
 If the machine starts, release the igni-
tion key.
Note: Never operate the starter motor for
longer than 10 seconds. Wait at least 10
seconds before operating the starter motor
again.
Drive the machine
 Set programme selection switch to
"Transport drive". .
 Move the gas lever all the way to the
front (high speed).
 Press brake pedal and keep it de-
pressed.
 Release parking brake.
Drive forward
 Set the travel direction switch to "for-
ward".
 Press accelerator pedal down slowly.
7