Grundig VCC 7070 A Mode D'emploi page 24

CLEANING AND CARE ______________________
3
Clean the cyclone separator and the dust
container bin with a soft brush and wipe
P
with a damp cloth.
Caution
Dry completely the separator thoroughly be-
█
fore replacing.
The cyclone separator should not be sub-
█
merged in water.
Never use detergents or boiling water to wash
█
the filters.
The dust container, including cyclone separator
█
must be inserted before the appliance is started
as otherwise the motor will be damaged.
4
Replace the dust container as directed. Make
sure that the cyclone separator is positioned
properly so that the notches on the sides of it
are lined up with the locking pins on the dust
container .
P
24 ENGLISH
Cleaning the motor
protective ilter
1
Press the dust container button
the dust container
P
2 Press the latch and take of the motor protec-
tive ilter cover.
3
Remove the ilter by pulling the tab towards
you.
4 Remove the foam ilter
. Each ilter can be tapped gently against
S
the side of a dust bin for removal of the excess
dust.
5
Shake out the ilter, wash it in warm water
(maximum 40ºC), thoroughly well and leave
to air dry.
Caution
Never put the filter into the washing machine or
█
dry it with a hair dryer.
Ensure the filter is completely dry before putting
█
it back into the cleaner. Allow to air dry for 24
hours before replacing.
Do not use detergents or boiling water to wash
█
the filter.
The filter must be inserted before the appliance
█
is started as otherwise the motor will be dam-
aged.
Do not wash the ilter holder
█
teriorated. Gently tap the edges or remove the
dust using another vacuum cleaner.
and remove
L
.
from the ilter holder
R
, it may be de-
S