Tl265Gs/Gs2065; Installation With Pc9155 Control Panel - DSC TL260GS Manuel D'installation

TL265GS/GS2065

Installation with PC9155 Control
Panel
1. Attach the Communicator to the inside of the
PC9155 control panel cabinet if not already
present.
NOTES: Install the TL265GS/GS2065 before
turning on the system.
Before inserting or removing the SIM card,
please ensure the unit is turned off.
• Separate the cabinet covers and place the
Communicator in the space provided.
• Attach the 5-pin PC-Link cable to the panel
(see the diagram in this section for orienta-
tion).
• Locate the Ethernet jack on the Communi-
cator and plug in the cable.
• Locate the 2-terminal block (beside the
Ethernet jack) labeled GND SHLD; it is
optional to attach a short wire between
these two terminals for noise reduction if a
shielded network cable is used.
NOTE: Do not attach this wire if the cable
shield is already grounded by the equip-
ment at the other end.
• Ensure the SIM card is inserted on the com-
municator.
2. Turn on the PC9155 cabinet and check signal
strength.
• Power up the unit.
• The red and yellow LEDs will flash together
while the communicator is initializing. The
red and yellow LED will continue to flash
until the unit has successfully communi-
cated to all programmed receivers. This
operation may take several minutes to com-
plete. Do not leave the installation until the
red and yellow LEDs have stopped flashing
and there are no troubles indicated by the
communicator.
• The green LEDs will indicate the signal strength. The bottom green LED must be On and solid - not flashing - for the location to be
acceptable. Please refer to Status LEDs on page 7 for more information.
TL265GS/GS2065 Communicator Wiring Diagram
NOTE: Model PC9155D uses the dual alarm
communicator GSM-GPRS/IP model TL265GS.
Model PC9155G uses the GSM-GPRS only
communicator, model GS2065.
NOTE: For wiring details for the PC9155,
refer to Installation Manual p/n 29007510.
Optional Antenna Kits
The PC9155 enclosure contains an internal GSM radio antenna. If the required GSM signal strength cannot be achieved using the internal
GSM antenna, the following selection of GSM extension antenna kits are available to the installer:
• GS15-ANTQ - 4.57m (15') Internal Antenna Extension Kit (suitable for interior mounting only)
• GS25-ANTQ - 7.62m (25') External Antenna Extension Kit (suitable for exterior mounting only)
• GS50-ANTQ - 15.24m (50') External Antenna Extension Kit (suitable for exterior mounting only)
PC9155D
UA558
PC9155G
T-1 R-1 TIP RING IO2 IO1 -AUX AUX+ AC AC
INPUT RATINGS (from PC-Link)
11.1V - 12.6 V
DC
100mA standby
400mA Alarm
PC9155
BATTERY
Do not disconnect the battery cable from the alarm controller board;
the battery shall be disconnected from the + (PLUS) TERMINAL.
UA557
RED
Red
Wire
Network Connection
(Available only for model TL265GS)
Use only CAT5 cable (300ft/100m max.)
Supervised.
6
ANTENNA
To Remove Connector -
insert small, flat head
screwdriver between cable
and the radio module then
gently pry plug loose.
NOTE: Removal with fingers
may damage the connector.
Red
Wire
TL265GS / GS2065
DSC
SIM Card
Holder
AUDIO/DEFAULT
SIM Card