Approved Mode; Weighing Units - OHAUS PR Serie Manuel D'instruction

EN-20

5.3.11 Approved Mode

Use this menu to set the Legal for Trade status.
OFF = standard operation.
ON = operation complies with Legal Metrology regulations.
Note: When Approved Mode is set to On, the menu settings are affected as follows:
Calibration Menu:
For InCal models, only Internal Calibration is available. All other functions are hidden.
For ExCal models, the entire Calibration menu is hidden.
Balance Setup Menu:
Filter Level is locked at the current setting.
Auto Zero Tracking is limited to 0.5 Division and Off. The selected setting is locked.
Auto Tare is locked at current setting.
Graduations are forced to 1 Division and the menu item is hidden.
Communication Menu (Communication->Print Settings->Print Output):
Stable Weight Only is locked On.
Numeric Value Only is locked Off.
Communication Menu (Communication->Print Settings->Auto Print):
Auto print mode selections are limited to Off, On Stability, and Interval. Continuous is not available.
Lockout Menu:
Menu is hidden

5.4 Weighing Units

Enter this sub-menu to activate the desired units of measure.
PR balances provide a choice of 10 units, which are all set On by default.
Note: Due to national laws, the balance may not include some of the units of measure listed below.
NTEP model: The Unit menu is used to enable or disable a specific unit. (SET ON, SET OFF).
Unit
Gram
Kilogram
Milligram
Carat
Pound
Ounce
Ounce Troy
Penny weight
Newton
Grain
Display
g
kg
mg
ct
lb
oz
ozt
dwt
N
GN
PR Series Balance
LFt