Hama 00054184 Mode D'emploi page 2

G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions and information
completely. Please keep these instructions in a safe place for future
reference.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to draw
your attention to speci c hazards and risks.
Note
This symbol is used to indicate additional information or
important notes.
2. Package Contents
• USB Charging Station
• These operating instructions
3. Safety Notes
• The product is intended for private, non-commercial use only.
• Protect the product from dirt, moisture and overheating and use
it in dry rooms only.
• Do not drop the product and do not expose it to any major
shocks.
• Do not operate the product outside the power limits given in
the speci cations.
• Do not open the device or continue to operate it if it becomes
damaged.
• Do not modify the device in any way. Doing so voids the
warranty.
• Only connect the product to a socket that has been approved
for the device. The socket must be installed close to the product
and easily accessible.
• Do not continue to operate the device if it becomes visibly
damaged. (This is mandatory for all products with 220 V mains
connections.)
4. Operation
Note
• The charger is suitable for a mains voltage of 100-240 V
and can be used around the world. Please note that a
country-speci c adapter may be necessary.
2
Note – USB-A port
• The USB port on the power supply unit can be used
to charge or operate USB devices such as tablet PCs,
smartphones, MP3 players, navigation devices, etc. The
maximum output current of the USB port is 2000 mA.
Note – Power Delivery
• Plug & go: No manual setup necessary, just connect
and start:
Voltage and power are automatically con gured by Power
Delivery.
• For e cient and optimised charging, the Power Delivery
(PD) function must be supported by your terminal device.
• With the large quantity of PD-enabled terminal devices with
different rmware versions, it can happen that the function
is not fully supported.
Warning – Connecting USB-C terminal devices
• Ensure that your notebook, tablet PC, smartphone or
console requires a power supply voltage of 5/9/15/20
volts (+/- 1 V).
• The speci ed supply voltage can be found on the original
power supply unit or in the user manual of your device.
• Ensure that the total power consumption of the notebook,
tablet PC, smartphone or console does not exceed the
power supply unit's rated output capacity of 60 W.
Unless the operating instructions for the devices you want to charge
explicitly inform you otherwise, proceed as follows:
• With the device switched off, connect it to the charger.
• Plug the charger into an easily accessible and properly installed
power outlet.
• Do not switch on the device for further use until you have
done this.
When charging batteries built into a device, pay attention to the
maximum charging time for the batteries.