Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Parts Included
A. Waste Bins (4)
B. Sliding Assembly
C. Mounting Screws (4)
A
B
C
Tools Required
• Phillips screwdriver
• Tape Measure
• Pencil
• Drill with 1/16˝ bit for pilot holes (optional)
Product Assemblies
SCB24-4-27
SBM24-4-27
2700 Oak Industrial Drive NE , Grand Rapids, MI 49505 USA
800.253.1561 • 616.459.3311 • www.kv.com
4-BIN RECYCLING CENTER
Installation Instructions
Inspect all parts and read all instructions prior to beginning assembly
and installation.
Place sliding base assembly on cabinet floor, centered behind the back edge of the cabinet face
1
frame. If installing in a frameless cabinet
align sliding base assembly parallel to cabinet opening. Close door to make sure the assembly will
not hold cabinet door open. Also, check to see if unit will clear the door opening when fully extended.
Once position is determined, fasten in place using four mounting screws provided and the Phillips
head screwdriver.
Optional Step
Mark placement of mounting holes with a pencil, remove sliding base assembly and drill pilot holes
for fastening screws. Place sliding base assembly back into position and fasten with the provided
screws.
Insert bin(s) into wire support frame to complete the installation.
2
1
Top View
Overall
Cabinet Width:
24"
BIN
BIN
BIN
BIN
BSC24-4-27
©2012 Knape & Vogt. All rights reserved.
Knape & Vogt
reserves the right to change specifications without notice. Made in USA.
®
, measure 3/4" back from front of cabinet opening, and
A
310167-D_0615
Publicité
Table des Matières
