Remote Mounting - Mettler Toledo IND131 Guide D'installation

Prepare the DIN module for mounting by attaching the supplied mounting brackets. (Figure 2-13).
On each side of the DIN module, slide the bracket down onto the rear housing, as indicated. Press
the bracket down until it is flush with the back of the rear housing.
Figure 2-13: Attaching DIN Module Mounting Brackets
Now, connect the keyboard/video harness to the DIN module, slide the module onto the four
threaded posts and use a hex wrench to install the four nuts, as shown in Figure 2-14
Figure 2-14: Installing DIN Module
2.2.4.

Remote Mounting

When the rear housing is mounted at a distance from the front panel operator interface, the panel
should be secured with the four special nuts shown in Figure 2-15. Tighten the nuts to 0.7 N-m (6
lbf-in).
2-8 METTLER TOLEDO IND131/IND131x/IND331/IND331xx Installation Manual 64067480 | 11 | 05/2018