Onkyo NS-6170 Manuel D'instructions page 9

> Before Start > Part Names
Connecting with a digital coaxial cable
The signal is converted to analog in the D/A converter of the
pre-main amplifier. Connect the COAXIAL IN jacks on a
pre-main amplifier with a digital coaxial cable to the AUDIO
OUTPUT DIGITAL COAXIAL jack on this unit.
Connecting with Onkyo RI Components
By connecting an Onkyo component with RI jack to the unit
by using an optional RI cable and an analog audio cable,
you can link the unit's power and input selection and enable
operation with this unit's remote controller. For details, refer
to the instruction manual of the component with the RI jack.
0 Some components may not support all RI functions.
a RI cable
8
> Install > Initial Setup
NS-6170
a
> Playback
Advanced Setup | Firmware Update | Others
Amplifier
E
N