Long Term Storage - Allmand MAXI-LITE Manuel D'utilisation

30
Long-Term Storage
Proper maintenance is required when the light tower trailer
will be stored or removed from operation for long periods of
time.
Refer to the Engine Operator's Manual and the Generator
Operator's Manual for all engine and generator long-term
storage procedures.
1. Lower the light tower to the full DOWN position.
2. Make any repairs necessary to make sure the equipment
is fully functional upon recommissioning.
3. Clean and wash the frame and body panels. Apply an
anti-corrosion coating to all surfaces where applicable.
4. Clean any oil or liquid spills inside the engine
compartment.
5. Drain the fluid containment system.
6. Clean all electrical wiring and components by hand using
non-corrosive cleaner.
7. Clean the light tower and light fixture assemblies.
8. Disconnect and remove the battery.
9. Use a suitable cover to protect the light tower and trailer.
10. Properly support the trailer axle on jack stands or other
suitable supports to allow the tires to remain off the
ground during storage.
Models and Serial Numbers
Model and serial number information is required for product
support and repair parts. Following are the model and serial
number locations of the primary components.
Trailer
The serial number plate for the light tower trailer is located on
the left front side of the unit (A, Figure 31).
31
Generator
The generator has a serial number plate (A, Figure 32)
attached to the side of the housing.
32
Engine
Kubota: The engine has a serial number plate (A, Figure 33)
attached to the top of the engine.
25