Transport Damage - Steinbach Poolrunner S63 Instructions De Service

Masquer les pouces Voir aussi pour Poolrunner S63:

Notice originale (320 pages)

Mode d'emploi (53 pages)

Notice originale (225 pages)

Table des Matières

Les langues disponibles

Warnings

Read all warnings and safety instructions

listed below. Non-compliance with the safety

instruction can result serious

• This equipment is not intended for use by an-

yone (including children) with restricted physi-

cal, sensory or mental ability, or with limited

experience and / or limited knowledge, unless

they are supervised by someone responsible

for their safety, or they receive instruction from

them regarding the use of the equipment.

• In order to prevent severe damage to the

cleaner, never power on the unit when it is out-

side of the swimming pool!

•

The device must be connected to an earthed

230 V protective contact

• Do not operate the cleaner when people are

in the pool.

•

If you pull the cleaner out of the water, do not

grasp the unit directly to the cable but at the

retaining bracket.

• Before switching on the unit and let espcape

the complete air.

•

Before power on, make sure the cable is fully

released to avoid any winding, which could

affect the cleaner's performance or cause

damage.

• The filter bags should be cleaned immedi-

ately every time you use the unit.

• The cleaner should be stored in a cool and

ventilated place, away from direct sunlight,

when not in use.

• The power supply unit should be placed in a

shaded area. In order to avoid overheating and

the potential damage of components, never

cover the power supply unit.

• Only authorized after sales service personnel

should open and repair the cleaner's motor as-

sembly and power supply unit.

•

The cleaner may only be used to clean

swimming pools. Any other use wages to the

immediate maturity of the warranty

•

Children may not use the

• The cleaner is not a toy.

• Do not uncover the protective film which is

sticked on the operating panel.

Poolrunner S63 | 2017_V1

accidents.

socket.

claim.

cleaner.

Warnings

The automatic pool cleaner is not suitable for

swimming pools with a foil thickness of less

than 0.4 mm. It may be possible in certain

circumstances that the liner gets damaged. A

use of the pool cleaner below the specified foil

thickness is at your own risk.

Introduction

Our automatic swimming pool floor cleaner Speedcleaner „Poolrunner

S63" is a new,

powerful and automatic system for cleaning swimming

pools. Through its advanced computer controlled program, it can

clean the pool floor automatically without draining pool water. At the

same time, it filters the pool water and gets rid of suspended particles

and sediments.

The Poolrunner S63 can only absorb loose debris

particles from the floor. An adherent contamination must still be

removed manually.

For safe operation, the cleaner works on 24V di-

rect current.

Please read these instructions carefully in order to use it

properly.

The automatic pool cleaner can be used for almost all standard pools

with flat, level

ground.

Safety

Your cleaner has been carefully tested after

manufacture and left the factory in perfect

technical condition. To maintain this orderly

condition and to ensure safe operation, the

user should always adhere to all recom-

mended instruction in this manual. If there are

indications that safe operation of the pool

cleaner can not be guaranteed, the product is

to be immediately unplugged from the electric-

ity supply and prevented from unintended re-

connection.

This is the case:

if the device shows visible damage

the

device

operational

after

prolonged

unfavorable conditions

When the power cord or other parts of this

appliance is damaged, it must be replaced by

the manufacturer or its service agent or a

similarly qualified person in order to avoid a

hazard.