Kuppersbusch ITE1370-1 Notice D'utilisation page 23

the in-line fuses (one per phase): 10 A at
230 V.
Important! Installation must be done in
conformance with the applicable codes, the
requirements of the standard NF.C.15100
and the requirements of the electrical
energy supplier.
Use a power supply socket that has an
earth connection and this must be connec-
ted in conformance with the standard
15100 and the requirements of the supplier
of electrical energy. this power supply sock-
et must be accessible. If the mains supply
Door reversibility
cable is damaged, it must be replaced by a
certified supply cable. This must be done
only by a skilled person, the seller or the
manufacturer. The appliance must not be
connected via an extension cable, a multi-
ple socket or a multiple connector (risk of
fire). Make sure the earthing connection
complies with the regulations in force.
We will accept no responsibility in the event
of accidents or incidents caused by non-ex-
istent or defective electrical earthing con-
nections.
The door of the appliance opens to the
right. If you want to open the door to the
left, follow these steps before you install the
appliance:
1. Loosen and remove the upper pin.
2. Remove the door.
3. Remove the spacer.
4. With a key, loosen the lower pin.
On the opposite side:
1. Tighten the lower pin.
2. Install the spacer.
3. Install the door.
4. Tighten the upper pin.
23