Additional Features - Uline Ohaus Ranger Count 3000 Mode D'emploi

RESET [RESET]
Reset the Lock menu to factory defaults.
• NO = no reset
• YES = reset
LOCK CAL [L.CAL]
Set the status.
• OFF = Calibration menu is not locked.
• ON = Calibration menu is locked.
LOCK SETUP [L.SETUP]
Set the status.
• OFF = Setup menu is not locked.
• ON = Setup menu is locked.
LOCK READ [L.READ]
Set the status.
• OFF = Readout menu is not locked.
• ON = Readout menu is locked.
LOCK UNIT [L.UNIT]
Set the status.
• OFF = Unit menu is not locked.
• ON = Unit menu is locked.
LOCK PRINT [L.PRINT]
Set the status.
• OFF = Print menu is not locked.
• ON = Print menu is locked.
PAGE 14 OF 69
MENU SETTINGS CONTINUED
LOCK COM [L.COMM]
Set the status.
• OFF = COM menu is not locked.
• ON = COM menu is locked.
END LOCK [END]
Advance to the next menu or return to the top of the
current menu.
END MENU
Press "No" to advance to the Calibration menu.
Press "Yes" to exit the menu and return to the current
application mode.

ADDITIONAL FEATURES

To use the weigh below feature, remove AC power from
the scale and remove the protective cover for the weigh
below opening. Install a suitable hook into the access
hole at the bottom of the scale as shown. Do not over
tighten, tighten finger tight. Mount the scale onto an
appropriate assembly that allows free working space
below the hook. (See Figure 4)
NOTE: Never allow the scale to rest directly on
the hook.
Figure 4
Weigh Below
Hook Access
1021 IH-9554