Descaling Of The Tip; Cleaning Of The Filter; Change Of Batteries In The Remote Control; Stop Due To Prolonged Absence - GALA INNOVA Manuel D'utilisation

4- Remove the tip by rotating it in an anti-clockwise direction.
5- Clean the nozzle.
6- Clean the tip.
7- Replace the tip on the nozzle.
8- Once the cleaning is finished, press the Stop button on the remote control or the auxiliary side control. Should you fail to do so,
the nozzle will move backwards automatically after 5 minutes. Once inside, it carries out a self-cleaning process.

4.3 DESCALING OF THE TIP

The holes in the tip may get blocked up due to limescale. Should this occur, the water flow diminishes and the
lights on the equipment blink 3 times, signaling that the tip must be descaled.
To descale it, immerse it in a liquid anti-limescale available in the market. Rinse and reinstall.
4.4 CLEANING OF THE FILTER m
We recommend carrying out the maintenance of the filter once every year to ensure a correct functioning of the device.
For the wall-hung model:
1
1. Close the shut-off valve.
2. Remove the filter with a screwdriver or a coin.
3. Clean the filter.
4. Replace the filter in its position ensuring it is properly installed and reopen the shut-off valve.
For the floorstanding model:
1
1. Close the shut-off valve.
2. Remove the filter with a screwdriver or coin.
3. Clean the filter.
4. Replace the filter in its position ensuring it is properly installed and reopen the shut-off valve.

4.5 CHANGE OF BATTERIES IN THE REMOTE CONTROL

The batteries needed for the remote control are two button batteries type CR-2032.
We recommend not mixing new and used batteries or batteries from different brands.
The remote control indicates that the batteries are running low with a quick blinking of the leds after a use. They
should be replaced then.

4.6 STOP DUE TO PROLONGED ABSENCE

If a long time elapses without using the Gala-Innova we recommend switching to Stand-By mode. See section 3.6
22
2
2
ENGLISH
Anti-cal
Anti-limescale
3
3
CR 2032 (x2)
1h