Settings With The Remote Control; Setting Of Temperature; Setting Of Water Pressure; Setting Of Position - GALA INNOVA Manuel D'utilisation

3.2 SETTINGS WITH THE REMOTE CONTROL

3.2.1 SETTING OF TEMPERATURE

The water and air functions have a temperature setting.
The water temperature has 4 levels:
• Room temperature (no led is switched on)
• Low temperature aprox. 33ºC (1 led switched on)
• Medium temperature aprox. 36ºC (2 leds switched on)
• High temperature aprox. 39ºC (3 leds switched on)
The air temperature can be adjusted in 4 levels:
• Room temperature
• Low temperature
• Medium temperature (2 leds switched on)
• High temperature
By pressing the plus symbol we can obtain a higher
temperature and by pressing the minus symbol, a lower
temperature.

3.2.3 SETTING OF POSITION

The nozzle can be adjusted in 5 positions. By
default it starts in a middle position allowing the
user to advance two positions and to move
backwards two positions.

3.3 AUXILIARY SIDE CONTROL

The auxiliary side control can be used to monitor the main product functions: Anal cleaning and
dryer.
This auxiliary side control allows the use with medium settings.
These settings may not be customised:
• Medium temperature
• Medium pressure
• Middle position
The functions may only be activated when the lid is open and the device detects a user.

3.3.1 ANAL CLEANING WITH AUXILIARY SIDE CONTROL

The position of the nozzle is established beforehand; so is the water temperature.
With the function activated, by pressing the same button again the oscillating function is activated. If it is pressed again, it returns to the
normal mode (not oscillating).
To stop this function, press the Stop button on the auxiliary side control or on the remote control.
The cleaning stops after 2 minutes if no other button is pressed.
If the drying button is pressed while the anal cleaning is taking place, the cleaning stops and the drying is activated.

3.3.2 DRYING WITH AUXILIARY SIDE CONTROL

The drying function is established beforehand with a medium temperature.
To stop this function press the Stop button on the remote control or the auxiliary side unit. The drying stops after 3 minutes if no other
button is pressed.

3.3.3 STOP WITH THE AUXILIARY SIDE PANEL

It stops any activated function.

3.4 CHANGE IN THE PRE-SET SETTINGS

3.4.1 CUSTOMISATION OF THE CLEANING AND DRYING SETTINGS

The Gala-Innova allows you to change the pre-set Temperature, Pressure and Position settings, which are controlled by the remote control
By default, these baseline values are:
• Medium temperature: 36º perineal and anal.
• Medium pressure: 0.55 L/min in perineal, 0.75 L/min in anal.
(no led is switched on)
(1 led switched on)
(3 leds switched on)
ENGLISH

3.2.2 SETTING OF WATER PRESSURE

The cleaning water pressure may be modified obtaining
a higher or lower water force in 3 levels.
By pressing the plus symbol we can obtain a higher
force and by pressing the minus symbol, a lower force.
19