Installation Precautions; Precautions For Use - GALA INNOVA Manuel D'utilisation

1.1.2 INSTALLATION PRECAUTIONS

This product should only be installed by qualified staff and with the provided
components. Please check the installation manual in order to obtain more
information on the electrical and water connections.
Make sure you fulfil the following precautions regarding the hydraulic
installation:
• Always connect the Gala-Innova to the domestic cold water mains.
• Rain water, demineralized water, sea water or grey water are not suitable to
operate this equipment. The Gala-Innova shower toilet may only be operated
with normal drinking water.
• When installing the water filter, make sure it is tightened adequately and in
its correct position.
• The pressure of the water supply of this device should be within the range of
0,05 to 0,9 Mpa.Make sure you fulfil the following precautions regarding the
electrical installation:
• Do not handle the socket with wet hands: To remove the plug from the
power outlet, do not pull the cable, always pull the plug.
• Always unplug the power cable before handling the product.
• Always use the specified supply voltage (220-240V, AC 50/60 Hz). The product should have an earth connection. It is necessary to install a circuit
breaker, exclusively devoted to the Gala-Innova.
• Do not use a poor or defective electrical connection.
• Place the socket correctly. It should be properly connected to the power outlet, firmly and completely.
• Remove the dust from the power outlet.
• Do not bend or squeeze the connecting tube or the power cable; and keep the cable away from humid, hot or sharp surfaces.
• Do not install the product in wheeled vehicles or boats.
Ignoring these precautions may cause fire, electric shock, short-circuit or damages to the device.
To confirm that the installation is correct:
• Check that the vitreous china piece is installed according to the provided installation manual.
• Check that the shut-off valve is open.
• Check that the power supply is connected to the Gala-Innova.
• Check that the remote control is connected to the Gala-Innova. (Should this not be the case, please see section 2.2.1).
When the Gala-Innova is connected to the power supply, the lights blink and a long beep may be heard.
The nozzle moves outwards and inwards.
The lights switch off and the Gala-Innova remains in a Stand-by mode, ready to be used.

1.1.3 PRECAUTIONS FOR USE

These precautions are important for a safe use. Make sure you follow them and use the product properly.
The Gala-Innova is a WC that has been designed for the cleaning of the anal and perineal areas.
It has been designed mainly for private use. Its use is restricted to enclosed spaces. Any other use will not be deemed in accordance
with its purpose and Gala will not accept any responsibility for the consequences that might arise from an improper use.
Should there be an operational failure, please check the Problem resolution chart (see section 5).
16
ENGLISH