Description Of The Manual Commands; Important - Lavorwash SWL 700 ET Manuel D'instruction

IMPORTANT:

Never collect string, wires, packaging straps, sticks etc., that are longer than 25 cm as they could
wind around the side and main brushes.
FILTERING SYSTEM:
Thanks to the sweeper's filtering effect no dust is seen in the environment when it is working. This is achieved by means of
filters Detail 3 Fig. 5; the filter system can be disengaged by pulling the knob Detail 4 Fig. 6 upwards.
IMPORTANT: Disengage the filter when going over damp surfaces (if the machine is running) otherwise the
paper filters will get damp causing them to deteriorate quickly.
DUST FLAPS:
See Details 4 of Fig. 5. These flaps are all around the main brush and are extremely important to ensure that the sweeper
works properly thanks to their suction effect; check them often to make sure they are always in a good state of repair.
REFUSE CONTAINER:
The refuse collector or container Detail A Fig. 1, is made in strong and resistant plastic and holds all the material collected by
the main brush and dust from the filters.
IMPORTANT: Always empty the container after the motor has been turned off, wearing gloves and even a mask to
protect your lungs from the dust which is always present in this operation.
SWL 700 ST/ SWL 900 ST/ SW 2600 SC / SW 3700 SC: Part. 1 - 4 - 5 - 6 – 9
SWL 700 ET/ SWL 900 ET/ SW 2600 BT/ SW 3700 BT: Part. 1 - 2 - 3 - 4 - 6 - 7 - 8 - 9
FORWARDS LEVER:
By pulling the forwards lever, Detail 1 Fig. 6 towards the handle, an internal mechanism is activated which causes the
moving of the sweepers at its own speed (forwards only). Traction will stop when you let go of this lever.
SIDE BRUSH ENGAGEMENT LEVER:
The engagement lever Detail 6 Fig. 6 makes possible to lower the brush from the driving seat. Remember that the side brush
must only be used for cleaning edges, profiles and corners and that it continues to rotate when the machine motor is working.
IMPORTANT: Never touch the side brush with your hands and never pick up threaded materials.
FILTER SHAKING KNOB:
This knob is used to shake (clean) the filter, Detail 3 Fig. 5 : pull it and leave it suddenly 5 or 6 times to mechanically shake
the filters; the dust on the filters will fall inside the container.
IMPORTANT: This operation must be carried out before starting works and before emptying the
container with the motor off or with suction disengaged.
________________________________________________________________________________________
ON THE BATTERY MODELS THIS KNOB IS REPLACED BY A VIBRATING ELECTRIC
BUTTON DETAIL 7 FIG. 6. TO CLEAN THE FILTER KEEP THIS BUTTON PRESSED FOR 4 /
6 SECONDS; REPEAT 5/6 TIMES.
_________________________________________________________________________________________
SUCTION OFF KNOB:
Detail 4 Fig. 6. When this knob is pulled outwards, suction is disengaged. Disengage the suction every time the filters need
shaking or when passing over damp areas (with the motor on).
FLAP-LIFT LEVER:
By pressing the flap-lift lever Part. 9 Fig. 6, the front seal lifts up for picking up a large objects. Suitable for collecting leaves,
cigarette packets, etc.
DESCRIPTION OF THE M ANUAL COM M ANDS DESCRIPTION OF THE M ANUAL COM M ANDS
Pag. 29