Controls; Model Identification - GOLDONI FC Serie Emploi Et Entretien

18.Tag plates and sticker are essential means of information on correct use of
the machine. Replace them when they are illegible or badly worn.
19.The operator must check to be certain that every part of the tractor and,
especially the safety devices, are in good working condition and work to
specs. They should be kept in perfect working condition. If you note any
malfunctioning, fix or repair them in good time. If necessary contact your
nearest Goldoni Assistance Centre. Failure to observe these instructions
releases manufacturer from all liability.
Pay special attention to the stickers on the machine.
Fig.10: refer to this Operating and Maintenance Instruction Manual.

2. CONTROLS

See fig.1.
1 Throttle control lever.
2 Clutch lever.
3 Gear lever.
4 PTO lever (FC).
4 Reverse lever (FC 3+2).
5 Engine stop button (Petrol versions) (FC).
6 Engine stop lever (Diesel versions) (FC).
7 PTO lever (FC 3+2).
8 Engine stop lever (Motorstop) (FC 3+2 - Professional).
9 Wheel release lever (FC 3+2).
10 Handle release lever (FC 3+2).
FC Professional
See fig. 2
3 Lever 1st - 2nd gear
4 Lever 3rd - 4th gear
5 Reverse lever (Forward gears: lever forward Reverse: lever back)
6 Brake lever (on right handlebar)
6 Clutch lever ( on left handlebar)
7 Implement release lever
8 Handlebar vertical adjustment lever (7 positions)
9 PTO control lever

3. MODEL IDENTIFICATION

Model, series and chassis number are the machine's identification data. They
are on a metal plate located, for FC Professional, on the right of the handlebar
post
For FC and FC 3+2 motor mowers, the data plate is on the left of the
handlebars.
38