Table Des Matières; Machine Component; Accessories; Safety Instructions - Tennant B1 Serie Manuel Opérateur Et Piéces

Machine component

1 - Handle bar
2 - Brush motor switch
3 - Housing of top shaft ele-
ment
4 - Swith lock
5 - Shaft adjustment handle
7 - Bar
8 - Cable hook
9 - Wheels
TABLE OF CONTENTS
Machine Components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Machine assembly and operation
Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Storage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Trouble Shooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Technical specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Parts List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PROTECT THE ENVIRONMENT
Please dispose of packaging materials and old
machine components in a safe environmentally
way according to your local waste disposal
regulations.
Always remember to recycle.
Specifications and parts are subject to change without notice.
Original Instructions. Copyright E2006- 2016 Tennant Company.
All rights reserved.

Safety Instructions

WARNING: This manual must be read and
understood before operating or servicing machine.
This machine is intended for commercial use. It's designed
exclusively to burnish hard floors in an indoor environment and
is not constructed for any other use. Only use recommended
pads/brushes and cleaning agents.
These operating instructions are intended for operating staff..
1. Please familiarize yourself with the instructions and
recommendations contained in these operating
instructions before setting up, operating and servicing the
machine.
2. You will then have full control over the machine and use it
efficiently. The care and maintenance described in these
operating instructions are in the interests of your own
safety and preserve the machine's value.
3. The manufacturer accepts no liability for personal injury
or damage to property due to the incorrect use of this
machine.
This warning alert symbol that is used
throughout this manual is to warn of hazards or unsafe
practices. Failure to follow these may cause electric
shock, fire or explosion which could result in severe
personal injury or death.
B1 9002027 (08- 17)
B1 Single disc machine
10 - Motor head
11 - Front wheels
12 - Pressing force regulator
14 - Overload indicator
15 - Buffer
16 - Shaft adjustment unit
17 - Drive plate for pads
2
3
3
. . . . . . . . . . . . . . . . . . . . . . . . 4
5
5
6
6
106

Accessories

Spray unit
n/s Suction ring
Vacuum unit
Filter bag
Before operating the single- disc machine, please read these
instructions carefully and keep them handy at all times.
The single- disc machine may only be used by persons trained
in its use and explicitly entrusted with its operation.
Children should be supervised to ensure that they do not play
with the appliance.
This machine is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge.
Connect power supply cable to a properly grounded outlet only.
Do not run appliance over cord. Electrical Hazard.
When using the vacuum unit, the floor must be dry.
WARNING: Fire or Explosion Hazard. Never use
flammable liquids or operate machine in or near
flammable liquids, vapours or combustible dusts.
This machine is not equipped with an explosion proof motor. The
electric motor will spark when powered on which could cause a
flash fire or explosion if machine is used in an area where
flammable vapours/liquids or combustible dusts are present.
WARNING: Electrical Hazard. Never operate
machine with damaged power supply cable. Do not
modify plug. Unplug cable before servicing
machine.
If the power supply cable is damaged or broken, it must be
replaced by the manufacturer or its service agent or a similarly
qualified person in order to avoid a hazard.
General remarks
The operation of the single- disc machine is subject to the
currently valid national regulations. It is essential to observe not
only the operating instructions and the binding regulations on
accident prevention valid in the country of use, but also the
generally acknowledged rules for safe and correct working
procedures. No methods involving safety risks must be used.
English EN
Part No.
9002262
9002287
9002288
9002195
3