4.
Pass the remote control cable through the supplied wire grommet,
and fit the grommet into the battery maintenance cover knockout.
5.
Plug the remote control cable into the 6-pin connector.
6.
Install the battery maintenance cover and tighten the cover screw.
REMOTE CONTROL CABLE
BATTERY MAINTENANCE COVER
7.
To avoid accidentally unplugging the remote control cable, secure
the cable to the generator frame with a cable tie as shown.
Never operate the generator
w i t h o u t t h e
maintenance cover in place,
as poor engine and generator
performance will result.
When the remote control is
not being used, replace it
w i t h t h e p l u g o n t h e
connector.
70
WIRE GROMMET
b a t t e r y
REMOTE CONTROL
CABLE
REMOTE CONTROL BOX
CABLE TIE
PLUG