Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
They may contain descriptions of accessories which do not appear in your appliance.
THIS EQUIPMENT COMPLIES WITH THE FOLLOWING REGULATIONS:
2006/95/EC on electrical safety, 2004/108/EC on electromagnetic compatibility, 93/98 on mark-
ing, 65/2014 on energy labelling 2010/30/EU 66/2014 on ecodesign 2009/125/EC, IEC 60704-2-
13, IEC 0335-2-31 Article 7 IEC 60335-1 Article 7-1
When the crossed-out wheelie bin symbol is attached to a product, it means that the product is covered by European Di-
rective 2002/96/EC.
Your product is designed and manufactured using high-quality materials and components which can be recycled and used
again.
•
Please take time to enquire about your local electrical and electronic waste sorting system.
•
Please respect local regulations and do not dispose of your used products with everyday
•
household waste.
•
If you dispose of your used product in the correct way, you will help to prevent any potential adverse
effects against the environment and human health.
This appliance should not be used by anyone (including children) with reduced psychic, sensory or mental
capacities or by anyone who does not have experience and knowledge of this type of appliance, unless they
are under the control and guidance of those responsible for their safety. Special care should be taken to make
sure that children do not play with the appliance.
The appliance should be assembled and connected by a qualified fitter*.
Use the pegs adapted to the support structure; consult manufacturers for details; seal if necessary. The com-
pany does not accept responsibility for any attachment fault due to drilling and pegging.
The hood is fitted with a 3 x 0.75 mm² HO5VVF power cord including a standardised 10/16 A plug with an
earthing system.
Type of protection: category 1
Power supply voltage: 220-240V mono - 50/60Hz.
Check that the voltage of the supply circuit is identical to the values indicated on the descriptive plate inside
the hood.
If the hood is directly connected to the network (without its plug), an omnipolar switch with a 3mm contact
point-gap should be installed just before the hood. The earth wire (yellow and green wire) should not be inter-
rupted by this switch.
•
For the appliance to operate effectively, we advise you to establish a height installation range between 0.65m and
0.70m over the hob. However, it is expressly forbidden to install any hood or suction unit at a distance under 0.65m
from the hob (risk of the filters catching fire). Fumes should rise naturally towards the extraction area.
•
Respect the outlet diameter of the appliance: the hood should under no circumstances be connected to a controlled
mechanical ventilation duct.
•
When the exhaust air is discharged in an exhaust duct, make sure that the duct is not already being used to channel
gases or fumes from any appliances powered by any energy other than electricity.
•
Place the hob as close as possible to the exhaust and prevent the build-up of crimps on the sheath in order to reduce
any pressure loss to the greatest possible extent.
In the event of installation, make sure that there is a regular air flow in the kitchen. Consider establishing one or more
•
air ducts whose cross-section is greater than or equal to the diameter of the discharge pipe, so that there is no nega-
tive pressure in the kitchen.
Provide sufficient ventilation whenever a cooking appliance or any other appliance simultaneously uses ambient air
•
from the room in which the hood is installed.
•
The maximum negative pressure created in the room should be less than 0.04mbar, which prevents a recurrence of
combustion gas.
•
The appliance must be positioned in such a way that the power socket is accessible.
These instructions are valid for several versions of the appliance.
ASSEMBLY RECOMMENDATION
*any failure to meet this condition invalidates the manufacturer's warranty and any action in the event of an accident.
Publicité
Table des Matières
