RDI Transform 73019237 Instructions Pour L'installation page 2

GATE KIT
Warning: Always wear safety goggles.
All steps in these assembly instructions should be completed on a clean, non-abrasive
surface. Steps and procedures in these assembly instructions assume the use of the
included Boerboel ® Gate Hardware Kit (hinges and latch).
GATE KIT COMPONENT LIST:
Check the kit to ensure all components are included.
A
B
C
D
E
F
H I J
L
M
N
2
A) Aluminum Reinforced Resalite
Uprights – 2
B) Telescoping Metal Support Brace – 2
C) Hinges – 2
D) Hinge Covers – 2
E) Allen Wrench for Hinges – 1
F) 1 ¼" Flat Head Phillips Screws (for hinges)
– 8
G) 1 ¼" Pan Head Screws (for hinges) – 10
H) Latch + Striker – 1
I) Striker Template – 1
J) 1" Phillips Screws (for latch) – 5
G
K) Latch Keys – 2
L) #8 x ³/ " Screws (For metal braces) – 4
8
K
M) #8 x ¾" Screws (For metal braces) – 4
N) #10 x 1" Screws – 4
TOOLS NEEDED:
– Safety Goggles
– Tape Measure
– Level
– Hacksaw or Chopsaw
– Rubber Mallet
– Drill
– Drill Bits
– #2 Square Drive Bit
– Spacer Blocks