Preparation For Use - auna Oakland Mode D'emploi

EN
32

PREPARATION FOR USE

Unpacking an setup
• Carefully remove the unit from the display carton and remove all
packing material from the unit.
• Unwind the AC power cord and extend it to its full length.
• Unwind the FM Antenna wire and extend it to its full length.
• Place the unit on a stable, level surface, convenient to an AC outlet,
out of Direct sunlight, and away from sources of excess heat, dust,
moisture, humidity or strong magnetic fields.
• Remove the opaque white plastic stylus cover from the phonograph
stylus by sliding it forward and down.
• Discard the stylus cover
• Remove the twist-tie that was used to secure the tone arm during
shipment.
• Release the tone arm lock lever.
• Connect the plug to your AC outlet.
Power source
This product is designed to operate on 230V 50Hz AC Mains only.
Attempting to operate this system from any other power source may cause
damage to the system, and such damage is not covered by your warranty.