Handling And Operation; Ga I; Ga Ii; Ga Iii - Blitz GA Pkw Manuel D'instructions

GB
12
Operating Instructions

Handling and Operation

5 Handling and Operation
5.1

GA I

Adjustment of supporting points
preset adjusting screws (Fig.5/1)

Adjustment of the incline
• If plate is loaded incline cannot be adjust-
ed with this model.
Securing of load
• Devices for securing of the load are not
part of the range of supply.
Fig. 5:
5.2

GA II

Adjustment of supporting points
loosen clamping screws (Fig.6/4) of the

sliding pieces
adjust desired width

clamp sliding pieces

Adjustment of the incline
• Incline is freely adjustable into all direc-
tions by means of adjustment screws.
• Change incline diagonally step by step:
first loosen screw (Fig.6/2) and then adjust
screw (Fig.6/3) etc.
• Use a fork spanner SW 24.
Securing of load
• Securing of the load is effected by nylon
belts. The flexible hose is made to protect
the belts at sharp-edged loads.
2
Fig. 6:
5.3

GA III

Adjustment of supporting points
1
loosen clamping screws (Fig.7/4) of the

sliding pieces
adjust desired width

clamp sliding pieces

Adjustment of the incline
• Incline is freely adjustable into all direc-
tions by means of adjustable gears.
• Use a fork spanner SW 17 to adjust the
spindle to the desired axle.
Securing of load
• Securing of the load is effected by nylon
belts. The flexible hose is made to protect
the belts at sharp-edged loads.
6
Fig. 7:
5
4
3
5
4
3134980 03/13