Remote Controller Operation - Hitachi KPI Manuel D'installation Et De Fonctionnement

5. REMOTE CONTROLLER OPERATION

5.1. LIQUID CRYSTAL REMOTE CONTROL PC-P2HTE
Liquid crystal display (LCD)
MODE FAN SPEED
VENTI LOUVER
Model: PC-P2HTE

Fan speed indicator
Indicates the ventilation speed selected:
-
(High / Medium / Low)
Indicator of Total ventilator
Indicates if the total heat exchanger has been selected.
-
A/C only air conditioning
-
VENTI only ventilation
-
A/C + VENTI if both are selected

Operation Mode Indicator
Indicates the operation mode selected:Fan/Cool/Heat/Dry/Auto
(Cool/Heat)

Run indicator (Red lamp)

RUN/STOP switch

MODE (Operation Mode Selection) switch

FAN SPEED (Fan Speed Selection) switch

Up & down panel operation switch

VENTI (ventilator operation) switch

LOUVER (deflector panel) switch

SELECT (Day/Schedule) switches
Increase and decreases the Day/Schedule for timer operation.

ON/OFF TIMER switch
Used to activate or deactivate the timer operation.
INSTALLATION AND OPERATION MANUAL
TIMER RESET
SCHEDULE OK
DAY
SELECT

OK switch

RESET (Filter Reset Switch)
After cleaning the air filter, press the "RESET" button. FILTER
indication will disappear and the next filter cleaning time is reset. It
also stops the run procedure.

TEMP (temperature setting) switches

T.RUN (test run indication)
Check (check indication)
These tests appear when TEST RUN or CHECK are being
performed.

ABNML (alarm) indicator

SET TEMP (set temperature) indicator

1234S indicator (setting schedule number)

Mon Tue ... Sun indicator (day of the week indicator).
Indicates that central station or CSNet control is operating.

Swing louver indicator
DEFROST indicator

SERVICE mode indicator.
Indicates the change to special operations

Time indicator.

Time indicator. (Indicates the programmed time).
To open the cover, pull in the
direction of the arrow.

NOTE:
When the system is restarted after a shutdown of more than
−
approximately 3 months, the system should be checked by your
service provider.
Turn off the main switch when the system is to be inoperative for
−
a long period of time. Otherwise the system consumes electricity
as the oil heater remains active even though the compressor is
stopped.
13